Adding IC Home devices to an IC Realtime NVR

Before you can add an IC Home product to a recorder, you must first add it to the IC Home App.

See here for instructions.

After connecting the devices to your local WiFi, You will need a PC with the ICIP DVR/NVR Finder Utility tool (ConfigTool) installed. Open Configtool to find the IP address of the DINGER or FLOODER.

Important: It is recommended that you set an IP reservation on the Router for the device as a static IP option is not available, otherwise it may disconnect from the recorder when the IP changes.

Web Interface.

Step 1.  Type in the IP address of the Recorder (NVR/ DVR/ AVR) into the address bar of a web browser and press enter. Log in to the NVR. 

Step 2. Go to the Setup tab. Under Camera/Image, go to Registration. Click on "Manual Add."

Note: The Device Search function on the Recorder can also scan the local network for the IC Home devices' IP address.

Step 3: Fill in the IP address, Port (37777 by default), username (admin) and the password that was setup for the device. Click OK to save.

Smart ICRSS

Step 1. Login to Smart ICRSS. Make sure you have added the Recorder to the software and the status is Online. Tap the "+" to open a new tab and select Device CFG. 

Step 2.  Select the Recorder on the left-hand side and then under Camera, select Remote Device.

Step 3.  Select Manual Add.

Step 4. Fill in the Device Name (This will be the camera's name in the recorder), IP address, Port (37777 by default), username (admin) and the password that was set up for the device. Click OK to save.