Skip to main content
Support
On this page

P2P IP Cameras

Applies to Cameras Updated 1 min read

This article will go over how to enable P2P on both legacy and current firmware iterations.

Legacy Firmware

  1.  Select SETTING on the main menu
  2. Select Network
  3. In the Network settings, select Access Platform
  4. Select P2P tab
  5. Ensure it is Enabled and status is online
  6. Select Save to save the settings

mceclip0

 

New Firmware

  1. Click the icon.
  2. Select "Network"
  3. In the Network settings, select Access Platform
  4. Select P2P tab
  5. Ensure it is Enabled and status is online
  6. Select Apply to save the settings

From here, check the box to "Enable" P2P and click "Save"

  • Lastly, verify the Connection Status. If it states "Connect Success -OR- Online" your cam has been setup for P2P access. You can continue with adding the cam to your mobile device or PC following this link:

Still stuck?

Our support team answers by email. It helps to have these ready:

Model numberSerial numberFirmware or app versionWhat you have tried
Contact supportSoftware downloads
Basic Motion Detection / Video Detection Enable Camera Microphone / Line In PTZ Idle Motion Setup Turning Off LED Lights What do I set the camera encode (video) settings to?